IP65 Waterproof Halogen Heater: 400V, 2500W, 300mm — Built for R7s Systems
We built this heater for the places where water, dust, and daily washdowns are just part of the job. Think plant floors that get hosed down, air that hangs heavy with humidity, machines that kick up grit. This is a quartz-tube halogen heater, 300mm long, putting out 2500W at 400V, and it plugs straight into R7s sockets. The whole point? Pack a lot of heat into a small footprint, and keep running without turning every day into a maintenance marathon.
Power, Voltage, Size — in plain terms
Here’s the thing about 400V: at the same wattage, it pulls less current than a 230V setup. Less current means less voltage drop over longer wire runs, and it helps keep terminal temps from creeping into the red zone. Then there’s the 2500W packed into a 300mm tube. That gives you serious watt density, so you get fast warm-up and tight control where you need it—like on a focused hot zone. But heat like that comes with a reality check. The gear around it has to be able to handle the warmth. If the surroundings can’t shed heat, the heater ends up living in a hotter environment, and that shortens lamp life. So give it some breathing room.
What’s inside, and why it stays tough
Inside, the halogen element sits in a sealed quartz tube. That sealed environment keeps output steady over time, because the regenerative halogen cycle helps slow down filament evaporation. In other words, it keeps doing its job without fading. And the IP65 sealing? It stands up to water jets and keeps dust out at the ends and joints. No intrusion means no shorting, no corrosion. It just keeps the inside dry and clean. The R7s connection is the simple part. It’s an industry-standard fit, so you can drop this heater into many existing fixtures without reworking the whole machine. You swap it in and get back to work.
Where it shines, and what it feels like to use
You put this heater in places that need quick, focused infrared heat—and where the environment is rough on equipment. It doesn’t flinch in wet washdown zones. It doesn’t quit in humid plant air. It stays solid in dusty enclosures, and the electrical integrity holds steady. The combo of 400V wiring, 2500W power, and a compact 300mm length means you can fit serious heat into tight spots. You get the intensity you need for consistent process temperatures, without fighting the space. Fast heat. Hardened against the mess. And the kind of reliability that lets you stop worrying about the heater and focus on the work.